Kris 90 Report post Posted June 23, 2020 I’ve looked through my manuals and can’t fine a diagram that shows how to attach the firewall insulation. This is the thick rubber piece with the mat foam. I have the 7 push in rubber clips but can’t figure out how it goes on. Quote Share this post Link to post Share on other sites
Brian Conway 264 Report post Posted June 23, 2020 Picture, phillips and large washer, is from my car. Might get you started or is this not the issue ? Brian Quote Share this post Link to post Share on other sites
Kris 90 Report post Posted June 23, 2020 I knew about the screws. There are rubber studs that go through the firewall. My car didn’t have them when I got it and the manual is zero help. Quote Share this post Link to post Share on other sites
Brian Conway 264 Report post Posted June 23, 2020 I was trying to suggest where to look, screw holes, for the original locations where you might try to attach your new pad. Quote Share this post Link to post Share on other sites
shelbyshelby 52 Report post Posted June 24, 2020 After I broke a few tips off those Rubber plugs by pushing them in, I used a piece of the inner thread of paracord to pull the rubber tip thru instead of pushing with tools. I just tied the string onto the tip and soaped it and the came right thru. Quote Share this post Link to post Share on other sites