Hux 45 Report post Posted June 7, 2020 Hi all I have a genuine rear valance but have replaced rear quarters and tank drop offs. The valance is a service part that was on the car but was held in place with a couple of tack welds so no idea if the shape has altered. The flange of metal where the quarter and tank drop off join is too long and holds the valance proud of the panel. Neither of the two panels is longer than the other so it’s not like one is the issue. Does the flange just need trimming back? Thanks in advance. Quote Share this post Link to post Share on other sites
Kris 90 Report post Posted June 7, 2020 I replaced both rear quarters on my car and the driver side putter fender. I had to trim the driver side pinch weld as you could tell it was clearly longer than the stock passenger side. Not it fits up nicely after making them match. Quote Share this post Link to post Share on other sites
RPM 1,190 Report post Posted June 7, 2020 Odds are somebody somewhere has an early Mustang where the quarters and valance meet without modifying, but I haven't heard about it. For those of us who like that joint at least close to acceptable, work needs to be done to the valance. Both ends of mine need work. Quote Share this post Link to post Share on other sites
Hux 45 Report post Posted June 8, 2020 9 hours ago, Kris said: I replaced both rear quarters on my car and the driver side putter fender. I had to trim the driver side pinch weld as you could tell it was clearly longer than the stock passenger side. Not it fits up nicely after making them match. Thanks Kris The pic is helpful as I can see where the flange has been trimmed at an angle to match. Such fun working with repop parts - NOT Quote Share this post Link to post Share on other sites
Ridge Runner 1,112 Report post Posted June 9, 2020 Well ,that isnt going to help fit a valance ,! [EDIT:] Nope, so the mods deleted it :) Quote Share this post Link to post Share on other sites
Hux 45 Report post Posted June 10, 2020 12 hours ago, Ridge Runner said: Well ,that isnt going to help fit a valance ,! [EDIT:] Nope, so the mods deleted it :) What did I miss out on....damn I love a good wind up Quote Share this post Link to post Share on other sites
Midlife 814 Report post Posted June 10, 2020 It was a spammer promoting his wares. Quote Share this post Link to post Share on other sites
Ridge Runner 1,112 Report post Posted June 10, 2020 Yep you were hit by a spammer ,he got the axe ! Quote Share this post Link to post Share on other sites
ralt962 11 Report post Posted June 12, 2020 Mine was mostly aftermarket. I did have to grind down the pinch weld flange to my the valance fit. The quarter panel was original, but the trunk and back panel with new, not OEM. Quote Share this post Link to post Share on other sites