69 red fastback 20 Report post Posted September 2, 2019 I need to replace my turn signal switch assembly, what is the best way to go about doing this? Also, where is the best place to get one? any info would be greatly appreciated. Thanks Quote Share this post Link to post Share on other sites
Caseyrhe 650 Report post Posted September 2, 2019 I’ve bought several from CJs and also from NPD with no issues Quote Share this post Link to post Share on other sites
danno 128 Report post Posted September 2, 2019 You need to remove the pins from the half moon connector they are inserted in. It takes a special tool. Some have improvised the tool out of a ball point pen. Quote Share this post Link to post Share on other sites
aslanefe 333 Report post Posted September 2, 2019 If you don't want to deal with removing the pins from the connectors, you can remove the collars from the column and get the connector and wiring out and in. Quote Share this post Link to post Share on other sites
69 red fastback 20 Report post Posted September 2, 2019 Thanks for the responses, what actually holds the switch in? Quote Share this post Link to post Share on other sites
Caseyrhe 650 Report post Posted September 2, 2019 3 minutes ago, 69 red fastback said: Thanks for the responses, what actually holds the switch in? 2 screws all my switches purchased came with the plug, except the tilt wheel blinker switch. Quote Share this post Link to post Share on other sites
69 red fastback 20 Report post Posted September 2, 2019 Gotcha, Thanks Quote Share this post Link to post Share on other sites
danno 128 Report post Posted September 3, 2019 I did not realize they all came with the plug. I have the tilt wheel, and it requires the pins removed. Quote Share this post Link to post Share on other sites