edwards54 15 Report post Posted June 10, 2019 Last week my rear passenger brake light and turn signal stopped working. The regular lights work and I know that they are wired differently than the regular lights. The front turn signal works and I understand that is not uncommon. I know it could be the switch but when I looked at the back wiring I saw a few things that I thought could be the problem. The first one is the ground wire is simply bare and is shredded. The red wire looks like it has been spliced and is also shredded. I will run a new ground wire but the red wire is where my question come from. Should that red wire be spliced like this and if so where should it run and connect to. The side marker light on that side also does work when the lights are turned on. Please let me know any suggestions you have. Thank you, Bob Quote Share this post Link to post Share on other sites
Midlife 814 Report post Posted June 11, 2019 It should be an orange/blue wire, and is your right side turn signal line. Quote Share this post Link to post Share on other sites
edwards54 15 Report post Posted June 11, 2019 Midlife, are you saying this should be connected to an orange blue wire? Quote Share this post Link to post Share on other sites
Midlife 814 Report post Posted June 11, 2019 Your picture is too small for me to make out details. What I see is a tail-light socket, and the only wire that comes close to red is orange/blue. Quote Share this post Link to post Share on other sites