door switch pigtail connector?

[newstang 388]

I can not believe that doing a search for this brings no results!

Is it possible these are not made?

 

[newstang 388]

well, i think i solved the problem. the pigtail is not made, but for some stupid reason, only the plastic part of it is. 

Luckily for me, I have the pin connectors to go in them from other plug connectors i use.

 

http://www.drakeautomotivegroup.com/Store/Product/C8AZ-14489-K.aspx?wid=141

 

 

[Midlife 814]

NPD carries them as well. 

Now then, the 1970 version of the door jamb connector uses 3 pins, and that connector is not reproduced.  Out of well over 400 I've seen (covering 70-73 models), I've seen about 3 intact ones.  The latches usually break off.

[Tain 63]

On 4/2/2019 at 12:48 PM, Midlife said:

NPD carries them as well. 

Now then, the 1970 version of the door jamb connector uses 3 pins, and that connector is not reproduced.  Out of well over 400 I've seen (covering 70-73 models), I've seen about 3 intact ones.  The latches usually break off.

I also was looking for this plug since the previous owner cut many of the connectors off the harness for the engine bay and the dash harness. 

[Midlife 814]

Looking for the two pin or three pin version?  I have both, but the 3 pin connector itself will be missing at least one tab.

[Tain 63]

6 hours ago, Midlife said:

Looking for the two pin or three pin version?  I have both, but the 3 pin connector itself will be missing at least one tab.

Looking the 2 pin one. 

[newstang 388]

I ended up ordering the plugs from summit, (Scott Drake) 

Ill just need to put in the pins/.