Jack Wheeler 0 Report post Posted February 26, 2019 As near as I can tell, the item shown in the attached pictures is called a windlace cap. It is part of the interior, which fits in the lower rear corner of the quarter window, on the inside of the car. It is purely a cosmetic addition which appears to cover up the end of the windlace around the side windows. The car I am working on is a 69 Mach1, and my question is, did all Mach1's have this piece? The one in the pictures came with the car in a box of assorted pieces, so I assume it was on the car at one point. However, I have seen a 69 Fastback (not a Mach1) which did not have this piece installed. It could have just been an oversight on the part of the person who restored it. Thanks for any guidance you can give me. Jack Wheeler Quote Share this post Link to post Share on other sites
Brian Conway 264 Report post Posted February 26, 2019 They were/are on my early Metuchen Mach 1. Brian Quote Share this post Link to post Share on other sites
Ridge Runner 1,112 Report post Posted February 26, 2019 Yes all fast backs had them Quote Share this post Link to post Share on other sites
Jack Wheeler 0 Report post Posted February 26, 2019 Thanks for the help (and picture)........ Jack Quote Share this post Link to post Share on other sites
fvike 173 Report post Posted February 27, 2019 All '69 FBs has them. '70 does not. Quote Share this post Link to post Share on other sites
SunnDogg 18 Report post Posted April 23, 2019 Does anyone have any pictures on how the windlace is supposed to run behind the cap and where the single screw for the cap itself mounts to? I am also about to install the quarter trim windlace and was hoping to find a good picture of how this should terminate at the top. I do not have the originals to go by and it looks like I need to trim the grooved portion at about a 45% angle to slide farther up the channel. Thanks in advance for any help. Quote Share this post Link to post Share on other sites
RPM 1,190 Report post Posted April 24, 2019 5 hours ago, SunnDogg said: Does anyone have any pictures on how the windlace is supposed to run behind the cap and where the single screw for the cap itself mounts to? I am also about to install the quarter trim windlace and was hoping to find a good picture of how this should terminate at the top. I do not have the originals to go by and it looks like I need to trim the grooved portion at about a 45% angle to slide farther up the channel. Thanks in advance for any help. Also needing this info. Quote Share this post Link to post Share on other sites
mustangstofear 608 Report post Posted April 24, 2019 We install a small screw to keep the wind lace down. 1 RPM reacted to this Quote Share this post Link to post Share on other sites
RPM 1,190 Report post Posted April 25, 2019 Thanks! Quote Share this post Link to post Share on other sites