RobotMan 264 Report post Posted January 3, 2019 Excellent. Thanks for the measurements. I will check my factory risers and post results. Won’t be back from vacation until week after next. Will check then. Quote Share this post Link to post Share on other sites
aslanefe 333 Report post Posted January 3, 2019 1 hour ago, SunnDogg said: Measuring in between the seat mounting holes on the angle it is approx. 2.5" tall. Not certain on the height of the OE pans as these were replaced when my car was out for body and paint. I've read in other posts that 69/70 risers are lower in general and people have installed these on other years to lower the seats, so that could be what Dynacorn is referring to when they say low-profile. Let me know if I can help with any other measurements. That dimension is about 3.5 inches on my 69 Grande with original floor and seat riser. 1 SunnDogg reacted to this Quote Share this post Link to post Share on other sites
RobotMan 264 Report post Posted January 14, 2019 On 1/3/2019 at 3:36 PM, SunnDogg said: Measuring in between the seat mounting holes on the angle it is approx. 2.5" tall. Not certain on the height of the OE pans as these were replaced when my car was out for body and paint. I've read in other posts that 69/70 risers are lower in general and people have installed these on other years to lower the seats, so that could be what Dynacorn is referring to when they say low-profile. Let me know if I can help with any other measurements. The new risers that came with my new floor pan are also about 2.5”. So probably about as good as can be. Thanks for the help. Quote Share this post Link to post Share on other sites