rays69mach1 11 Report post Posted October 12, 2018 If I install a T5 in my 69 Mach1 will the shifter line up with the hole in the center console? Ray Quote Share this post Link to post Share on other sites
fvike 173 Report post Posted October 12, 2018 Yes. http://www.mustangandfords.com/how-to/drivetrain/mump-0307-how-to-install-a-five-speed-in-vintage-mustangs/ Quote Share this post Link to post Share on other sites
bosephus 10 Report post Posted October 14, 2018 I had to do a little whittling on the Pro shift shifter that came with my t-5 . IIRC it had a big ring on the top of the shifter that wouldn't allow it to come through from the bottom so I trimmed a "flat" on each side. This may have been limited to the particular shifter I had or I might have had the room to bolt the shifter on from the top after installing the transmission(I didn't want to remove the transmission again if I didn't have the room). But no mods to the tunnel were made. Quote Share this post Link to post Share on other sites
rays69mach1 11 Report post Posted October 14, 2018 Ok thanks for the info. Ray Quote Share this post Link to post Share on other sites
