Mach1 Driver 560 Report post Posted September 10, 2018 For those of you that have installed an MSD ignition, where did you position the box? I would like to keep it as unobtrusive as possible. Quote Share this post Link to post Share on other sites
1969_Mach1 333 Report post Posted September 10, 2018 I installed mine in the engine compartment, attached mine to the left inner fender panel in front of the shock tower. It has good ventilation and air flow. But, definitely not hidden. Many people find a location inside the car to hide it. For me, it was more important it has good air flow. Quote Share this post Link to post Share on other sites
Mike65 475 Report post Posted September 10, 2018 I used the Petronix Digital HP ignition box & I mounted it on the l/s front inner fender panel along with the 2 electric cooling fan relays between the shock tower & the washer bottle. Quote Share this post Link to post Share on other sites
Cantedvalve 128 Report post Posted September 10, 2018 When I had one, I mounted it on the apron under the battery. I took the battery tray, and cut off the bottom bracket, so that it was just the tray. That gave me enough room to mount it down on the panel under the tray. The battery tray was still stable as I had it bolted up top as well. If you look at the middle left, you can see it sitting down there. The battery IS installed in this shot. I did paint it black to make it hide better. Quote Share this post Link to post Share on other sites
Rsanter 152 Report post Posted September 10, 2018 I put mine on the driver inner fender panel, but a friend mounted his under the dash, he then split the tape on the gauge harness and ran the wire with that and rewraped the harness. you would have to look very carefully to see that he had an MSD or anything added Quote Share this post Link to post Share on other sites
lanky 44 Report post Posted September 10, 2018 I plan on mounting mine under the passenger side dash since there's more room on that side. I think cleaner looking is always the best, unless function is sacrificied. MSD says it's fine to extend the leads as long as you upsize each lead 1 size. I have read glove boxes are a terrible idea because air flow IS important. In that regard, make sure it's away from your heating ducts if you do mount it inside. As far as where to go through the firewall...I'm open to ideas. Admittedly I've already put more holes in mine than I should have for wires. EDIT: don't forget to set your limiter before final mounting! Turning the knobs could be difficult if its under dash etc Quote Share this post Link to post Share on other sites
Mach1 Driver 560 Report post Posted September 11, 2018 2 hours ago, Rsanter said: a friend mounted his under the dash, he then split the tape on the gauge harness and ran the wire with that and rewraped the harness. you would have to look very carefully to see that he had an MSD or anything added Some people complain that the box makes buzzing noises- has he noticed that? Quote Share this post Link to post Share on other sites
EastYorkStang 63 Report post Posted September 16, 2018 I had mine on the passenger side floor board just in front of their feet. Recently moved it to where the battery was on the pass side apron when I moved the battery into the trunk. Quote Share this post Link to post Share on other sites