69Stanger408 82 Report post Posted February 6, 2018 Brand new restomod with no wiring. Starting to wire up car with a new Painless Harness. Besides normal electrical needs (dash, lights, radio, etc) here are my requirements which are out of the norm: Power Master High Torque Starter w/built in solenoid (would like to use internal solenoid vise external), 1 wire 100 amp alternator (would like to use internal regulator vise external), Trunk mounted battery. Best layout / Any suggestions? Quote Share this post Link to post Share on other sites
Vicfreg 771 Report post Posted February 6, 2018 69Stanger.... I just finished my AAW harness install. You can see the details on my project thread - 1970 Convertible Restoration. I did the following on my build which should cover just about anything you need to do. Happy to answer any questions. Trunk mounted battery 140 amp single wire alternator Vintage Air Fuel Injection Electric Fans Electric Fan/trans cooler VHX dash PWM fan controller Starter solenoid in trunk - starter wire only hot when starting Power distribution terminal blocks Grounding distribution terminal blocks Wiring routed in fenderwells Regards, Vic 1 69Stanger408 reacted to this Quote Share this post Link to post Share on other sites
69Stanger408 82 Report post Posted February 7, 2018 Vicfreg, I reviewed your thread, thanks for the additional motivation, your attention to detail is outstanding! Quote Share this post Link to post Share on other sites
Vicfreg 771 Report post Posted February 7, 2018 Thanks.... Keep in touch as you go along with your project. Vic Quote Share this post Link to post Share on other sites