strokerman 0 Report post Posted January 27, 2018 dynacorn any good. I saw a post on them. need to either fix or replace one side upper hinge. thanks. Quote Share this post Link to post Share on other sites
Mike65 475 Report post Posted January 27, 2018 I would rebuild the ones you have & contact MUSTANGSTEVE about getting the parts to have greasable door hinges with the zerk fittings. Either you can DIY or have MUSTANGSTEVE do it. Here is a link to his page. https://www.mustangsteve.com/hinge.html 2 SWPruett and Chelby-Ann reacted to this Quote Share this post Link to post Share on other sites
strokerman 0 Report post Posted January 27, 2018 yes I did read steves new pin set.. thanks. Quote Share this post Link to post Share on other sites
strokerman 0 Report post Posted January 27, 2018 not sure I want to go that route. just replace for now.. but thanks. Quote Share this post Link to post Share on other sites
Bob & Sue 110 Report post Posted January 27, 2018 West Coast Classic Cougars Mustangs has the rebuilt with zerk fitting. They also have a good you tube video on changing the hinge pin without removing the door. https://secure.cougarpartscatalog.com/69zhinge-right.html?attribs=88 Also has the rebuild kit with zerk fitting for 2 hinges. https://secure.cougarpartscatalog.com/69zhinge-right.html?attribs=88 Quote Share this post Link to post Share on other sites
strokerman 0 Report post Posted January 27, 2018 yes I watched it last nite. guy is good. thanks Quote Share this post Link to post Share on other sites
69RavenConv 286 Report post Posted January 28, 2018 Replacing the OEM style pins and bronze bushings is also an option for less money. That's what I did. https://secure.cougarpartscatalog.com/bush.html Granted, it's not nearly as robust as the grease filled zerk kits but it is a lot cheaper. When these cars were daily drivers and the doors were getting opened and closed a dozen times a day, 365 days a year, the hinges wore out. I figure my car is now a toy that gets driven a a couple dozen times a year so the OEM style should last me a lifetime. The zerk style would probably last 5 lifetimes but that's more than I'm going to need. :) 2 Chelby-Ann and Caseyrhe reacted to this Quote Share this post Link to post Share on other sites
Vicfreg 771 Report post Posted January 29, 2018 I did the bushing install with a kit that had zirc fittings, and did not have to weld them in. I will have to go look to see where I got them, but very happy with the result. I would not buy aftermarket hinges...... Quote Share this post Link to post Share on other sites
Rsanter 152 Report post Posted February 1, 2018 The replacement bushing and pins are easy to replace unless the stamped part is bad I would rebuild what I had. i did that with my 69 no problem Quote Share this post Link to post Share on other sites
CG in TX 16 Report post Posted February 1, 2018 No issues with my new Dynacorn hinges. To me it seems easier than messing with the old worn out ones. Quote Share this post Link to post Share on other sites
