aslanefe 333 Report post Posted November 12, 2017 Below are pictures of a paint booth I came up with. You can adjust the length and width. You can take it apart and store it when you do not need it. Used 1/2" and 3/4" conduit for the metal parts. Cover it with thin plastic, tape it up. When you are done remove and discard the thin plastic (keep the thick plastic on the doors and back structure. Pictures should give you an idea on the construction. Quote Share this post Link to post Share on other sites
Bob & Sue 110 Report post Posted December 28, 2017 Great timing I was just making a material list to build one similar to this. I'm making it lightweight with 1-1/4" PCV tubing the 3 way corner connectors will be drilled with cotter keys with 1 or 2 roof rods for rigidity , the door will be heavy clear with magnets to hold them closed, fan end will be heavy clear with a small frame for fan. Just picked up a 3 piece heated water separator/filter (1 heater, 1 separator. 1 charcoal filter cartridge). I'll take some pics this spring when I get it together. Quote Share this post Link to post Share on other sites
aslanefe 333 Report post Posted January 1, 2018 You might want to compare the weight of 1/2" steel conduit and 1 1/4" PVC if you are going for light weight. 1/2" metal conduit is real stiff compared to 1 1/4 pvc and do not bend much when suspended free. I can adjust the length and width of mine and collapse it (including the fan/filter box) by removing the conduits for storage. It is tucked by the wall during storage and takes up 8x2 feet of floor space. Width can't be smaller than the fan box and door frame when assembled. Quote Share this post Link to post Share on other sites
Viperpete 36 Report post Posted September 29, 2018 Can't see the pics! Quote Share this post Link to post Share on other sites
RPM 1,190 Report post Posted September 29, 2018 29 minutes ago, Viperpete said: Can't see the pics! That's because a LOT of the images here were deleted a while back to make room for us to continue operating. Quote Share this post Link to post Share on other sites
Viperpete 36 Report post Posted October 3, 2018 oh ok, gotchya. fwiw, i use postimage.org free to upload images and then i just post a link to the photo- takes no bandwidth. Quote Share this post Link to post Share on other sites
aslanefe 333 Report post Posted October 4, 2018 I am currently painting a 69 Grande using that booth, will post some pictures when I can. It works fine, creates decent positive pressure with 4 box fans. Quote Share this post Link to post Share on other sites
aslanefe 333 Report post Posted October 22, 2018 Here are the pictures that were deleted. Will see how long these will stay. To cover the top and sides I used 9 feet wide thin plastic, the kind you buy from home depot or like to use as drop cloth, Quote Share this post Link to post Share on other sites