MAC390 327 Report post Posted September 24, 2017 Got my new repop roof medallions , the mounting pins were none existent . I am going to glue them on , could someone give me some dimensions to where they sit. Thanks. Quote Share this post Link to post Share on other sites
Ridge Runner 1,113 Report post Posted September 24, 2017 I have had a couple of fast backs where the pins must have broken off at the factory while putting the medalions on ,they used small wood screws and the medalion worked perfect Quote Share this post Link to post Share on other sites
MAC390 327 Report post Posted September 24, 2017 Hey Ridge, do you have any dimensions for the position. I would certainly use the wood screws. Quote Share this post Link to post Share on other sites
Brian Conway 264 Report post Posted September 24, 2017 No dimensions but have a picture, my car, that could help out? Just took a look and appears; 5.5" up and 5" horizontally from the stainless drip rail will get you to center. Brian Quote Share this post Link to post Share on other sites
Caseyrhe 650 Report post Posted September 24, 2017 Most auto body shops have the screw in rivets. Believe they are the same size rivets the rear fastback trim clip uses Quote Share this post Link to post Share on other sites
stangnet33 88 Report post Posted September 25, 2017 1 MAC390 reacted to this Quote Share this post Link to post Share on other sites
stangnet33 88 Report post Posted September 25, 2017 After doing this I realized that you probably have your boomerang moulding on. Quote Share this post Link to post Share on other sites
Caseyrhe 650 Report post Posted September 25, 2017 He does not Quote Share this post Link to post Share on other sites
MAC390 327 Report post Posted September 25, 2017 Thanks stangnet33 and Brian. Those dimensions will help heaps. Quote Share this post Link to post Share on other sites