MUST 25 Report post Posted September 19, 2017 Hi Guys, does anyone know this part? Or perhaps just ordered and not installed yet? "Rear Seat-To-Trunk Divider Steel 1969-1970 Mustang Coupe" An order to Germany would exceed the costs. Maybe someone have the part and could send me the measurements? just a question.. But, that would be absolutely awesome. BR Tom Quote Share this post Link to post Share on other sites
aslanefe 333 Report post Posted September 19, 2017 You have a car right? Just make a mock-up from cardboard using your car, then transfer it to steel sheet and cut, paint, install. 2 RPM and Caseyrhe reacted to this Quote Share this post Link to post Share on other sites
Mike65 475 Report post Posted September 20, 2017 Tom, I have one I have not installed yet, here are the measurements from mine. Across the top - 54 3/4" top to bottom - 19 1/2" l/s to r/s at lower part of wheel well cut out - 43 1/2" At the bottom on each side are little cut outs, from the inside lower part of each cut out is - 38 3/4" the cut outs are 1 3/16" high from the top of the panel to the top of the cut out for the wheel well is 4 5/8" I had to make a extra cut for the l/s package tray retainer clip by the cut out for the rear seat back top mount. (see my attached pic) Here is a pic of it laid in place in my 69 Coupe. Quote Share this post Link to post Share on other sites