Kaspar 21 Report post Posted August 31, 2017 My C4 is starting to behave a little annoying. It won't go from Park to Reverse, though I have no problem going from Neutral to Reverse. Thoughts? Quote Share this post Link to post Share on other sites
skidmarky 50 Report post Posted August 31, 2017 linkage need adjusting? Quote Share this post Link to post Share on other sites
J's69Mach1 17 Report post Posted August 31, 2017 Yeah my son's 66 mustang c4 , had similar problem. linkage was hitting a loose cable. I cleared it, problem solved. Quote Share this post Link to post Share on other sites
Kaspar 21 Report post Posted August 31, 2017 I'm trying to adjust the linkage but can't seem to make it better. How much/little do I need to adjust? Are we talking 1-2mm? Quote Share this post Link to post Share on other sites
LoneWolf2U 136 Report post Posted September 2, 2017 On 8/31/2017 at 10:08 AM, Kaspar said: My C4 is starting to behave a little annoying. It won't go from Park to Reverse, though I have no problem going from Neutral to Reverse. Thoughts? First place to look at is the detent plate and has the cable gone slack when button pushed. now check the slots on the plate for burrs or rounded corners. Next are the bushings on the lower linkage for wear and finally adjustment on link Quote Share this post Link to post Share on other sites
69ShelbyGT350H 61 Report post Posted September 2, 2017 There is a cable that runs up the shifter shaft that does not have any adjustments. It makes a sharp 90 degree turn at the top under the "T" handle and this is usually where the problem with the cable is at. If the cable stretches, when you press the button on the handle it does not lift the detent high enough at the bottom of the shifter shaft to clear the P to R detent. You can use an allen screw to remove the "T" handle and look at the cable. You can also manually activate the cable to see if you can get to operate correctly. If so you need a new shifter shaft. Quote Share this post Link to post Share on other sites