TexasEd 188 Report post Posted August 6, 2017 I took my original 302/2v cast iron manifold and other parts to a guy to media blast them so I could repaint them. I put the manifold back on and I'm now hooking up vacuum lines and the fitting at the back of the manifold is missing. I've searched 4 or 5 parts sites so far and I'm not finding anything. It's been several years since I had them cleaned. I doubt I'll get the original one back. Any ideas on where to find something for this? Quote Share this post Link to post Share on other sites
LoneWolf2U 136 Report post Posted August 6, 2017 Well your choice is hit the junk yard or go with a vac tree connector from your local parts house with a nipple in the intake. Quote Share this post Link to post Share on other sites
TexasEd 188 Report post Posted August 6, 2017 Trying some different search terms I found this at NPD. https://www.npdlink.com/store/products/fitting_vacuum_port_rear-143685-1.html Is this what I need? I have auto transmission, manual brakes, and AC. I know I need to route vacuum a few different places and can't make sense of the vacuum diagram in the manual. I was planning to hook up the PCV directly to the carb and I have a large port on the back of the carb spacer I have not figured out yet. Quote Share this post Link to post Share on other sites
TexasEd 188 Report post Posted August 6, 2017 Probably going to try the pick a part route. See what I can find. Quote Share this post Link to post Share on other sites