69Stanger408 82 Report post Posted June 16, 2017 Is there a mounting plate available for the Wilwood master cylinder for non power brakes? The existing firewall holes for the OEM system are visable due to the OEM booster that is not being used. Wilwood says they don't carry anything for this . Quote Share this post Link to post Share on other sites
RPM 1,190 Report post Posted June 16, 2017 I think MustangSteve.com has one. It was him or eBay maybe. Quote Share this post Link to post Share on other sites
69Stanger408 82 Report post Posted June 17, 2017 Lack of patience...picked up some 1/4 aluminum, hour on the band saw & drill press, and complete. Now need to finish with paint. Quote Share this post Link to post Share on other sites
RPM 1,190 Report post Posted June 17, 2017 ...or you could do that. Nice work! Are you going to use a gasket or rtv type goop? Quote Share this post Link to post Share on other sites
Hoover 12 Report post Posted June 17, 2017 The lower two bolts appear to be too short. Are they drawn up tight, or just run on the bolt? Any way the mounting plate looks well made. Quote Share this post Link to post Share on other sites
69Stanger408 82 Report post Posted June 17, 2017 13 hours ago, RPM said: ...or you could do that. Nice work! Are you going to use a gasket or rtv type goop? Thanks, rubber gasket, trace and cut. Quote Share this post Link to post Share on other sites
69Stanger408 82 Report post Posted June 17, 2017 12 hours ago, Hoover said: The lower two bolts appear to be too short. Are they drawn up tight, or just run on the bolt? Any way the mounting plate looks well made. just temporary bolts, will use different ones for the actual Quote Share this post Link to post Share on other sites