stangnet33 88 Report post Posted April 9, 2017 So I picked up these rear rails online and not sure to be disappointed or not. Hopefully for those that have replaced their full rails could chim in if they had welded sections on them or not and brand they were. Quote Share this post Link to post Share on other sites
Ridge Runner 1,112 Report post Posted April 10, 2017 Last rail i did ,did not look like that Quote Share this post Link to post Share on other sites
Ridge Runner 1,112 Report post Posted April 10, 2017 I had to check,my last rails were Dynacorn and looked like the originals . Quote Share this post Link to post Share on other sites
MAC390 327 Report post Posted April 10, 2017 Just looked at my buddies frame rails which are Dynacorn and they are the same as Ridge Runners. Quote Share this post Link to post Share on other sites
stangnet33 88 Report post Posted April 10, 2017 Well isn't that just a swift kick to the nuts . Thx fella's Quote Share this post Link to post Share on other sites
Ridge Runner 1,112 Report post Posted April 11, 2017 Kind of looks like someone tried thier hand at modifing ..and failed .then they placed them on EBay for some ...um ..er ...ah..poor shmuck ..to relieve them of thier shame ,and get paid for it in the process . I hope you gave them the good review they really should get for thier troubles Quote Share this post Link to post Share on other sites
Rsanter 152 Report post Posted April 12, 2017 I think they used to sell the tree piece frame rails for a couple reasons. you could buy just the section you need, they ship easier, and they are easier to make. personally I would not use those when good single piece or good used ones are available bob Quote Share this post Link to post Share on other sites
stangnet33 88 Report post Posted April 13, 2017 Just in case anyone cares, while I was looking through one of the vendors I happened to find these rails and they are a Scott Drake part. Quote Share this post Link to post Share on other sites
TurboStangGT 7 Report post Posted April 18, 2017 these's are made by " Mr. Mustang" out of ohio they were the very first repro rear frame rail. they have been making parts sense 1975, years before anyone knew the name Dynacorn Quote Share this post Link to post Share on other sites