1970 Mach 1 restoration help needed

[d&dmach1 1]

If anyone is in the process of restoring a 1970 Mach 1, I am looking for some help in learning what the rocker moulding assembly clips look like.  The clips in question are for the lower rocker panel and are pop riveted to the body.  There are 8 on each side and we have not been able to find them after having taken them off 6 years ago.  If anyone has any pictures of an earlier resto or one going on presently I would really appreciate some assistance.

 

Thanks

[fvike 173]

Buy these manuals. They show you every clip, screw and bolt on the car.

 

http://www.ebay.com/sch/i.html?_from=R40&_trksid=p2050890.m570.l1313.TR0.TRC0.H0.X1970+Mustang+Assembly+manual.TRS0&_nkw=1970+Mustang+Assembly+manual&_sacat=6000

[d&dmach1 1]

I already have them, and if the pic is correct I know what they should look like.  Since I may have to have them made, was hoping to get some dimensions also.  Thanks for replying.

[RPM 1,190]

Good luck locating some. Have you tried any Mustang salvage yards?

[69MC 14]

Did you try NPD, item #29076-1AK Mounting Kit, Rocker Molding 1970 Mach 1 - $30.00.

[d&dmach1 1]

Thanks, but NPD hasn't had stock of this item since 2011. They have no idea if they ever will again.

[Kris 90]

Are these the same little white pieces used for the long thin rocker molding?

[d&dmach1 1]

I do have the manuals, and the part is not available from any supplier so far. They are a metal clip with a top protruding from the body that the aluminum rocker moulding will hang from, while the bottom edge is screwed on. Specific to 1970 Mach 1. I have an idea what they look like, was just hoping to get some confirmation and dimensions.

[d&dmach1 1]

Found a picture from a salvage yard. Once I knew what to look for I was able to find them in the shop. Thanks to all who replied.

[RPM 1,190]

Good news that you found them. Can you kindly post a pic and where you bought yours for the next guy that needs them? Thanks.