Dual exhaust hanger mounting locations

[stuart 13]

I'm installing a factory dual exhaust kit in my Mustang originally equipped with a single exhaust.  Does anyone have a picture or template of where to drill the holes beneath the floor pan for the exhaust hangers?

 

thanks,

Stu

[Ridge Runner 1,112]

These are from my R code   Driver  side

 

Pass. side .

measuring from the center of the seat belt bolt hole on the driver side 2 3/4 to the bottom hole

 

Yours may not have the reinforcement pan in the floor so i measured from the line above the bolt hole ,1 7/8 inches.

 

[Rsanter 152]

I installed a dual exhaust system in my 69 but did not want to add holes in the floor.

I used the hangers like would be used with a boss car and the 351c cars use.

They are the ones that go,up and bolt into the rear shock cross member.

A single exhaust car will have one of them so that side has the nut plate installed. On the other side I made a square U bolt that slipped in and I used nuts to attach the bracket. Worked slick and no modifications to the car

 

In the back I fabbed brackets that bolted to where the tie downs attach.

 

Bob

[stuart 13]

Thanks for the help guys, this is extremely helpful.

 

Stu

[mustangmike6996 34]

_{I used that Flowmaster kit and it had me drill holes like the red floor pans in the above post.  If you do drill, prime and paint the holes.}