Kris 90 Report post Posted September 6, 2014 (edited) Trying to clean out the garage and get rid of the spare parts I have been holding onto. I can post pictures of anything anyone is interested in. Most parts are originals but there are a few new parts also. 1. 69-70 Factory shock tower braces (pair) from cowling to shock tower for v8 car orig. 2. SOLD 3. 64-73 Set of automatic shifter shields, the blue and black plastic parts inside under the pointer, these are not orig but are not made aftermarket by any distributor 4. 1967 wheel center cap, original red with running horse, good for driver 5. New 68-69 rear axle brake line kit. This is stainless steel and is made by classic tubing. It is for a 9" 28 spline axle it can be used for a 8" also. 6. 69-70 inner and outer door handles, originals, outers have scratches, inners have some pitting 7. 69-70 mustang manual steering gearbox, functions but does have play in the steering wheel, may just need to have the adjustment tightened, changing over to a different setup so I do not need it 8. SOLD 9. 65-73 mustang original drive shaft 10 SOLD 11. 69-70 mustang original standard hood 12. 69 mustang passenger side original glue in door glass. This is for a coupe / convertible and is the hard to find factory green tinted glass and is not chipped or broken. This does not include the stainless trim that goes on the back edge. 13. 1969 mustang original front valance. This is in good condition with no major damage but does have quite a few small dents in the middle that will be behind the license plate or could be worked out. Has been stripped and primed. 14. 69-70 mustang automatic transmission shift selector indicator shield, this is the black plastic rounded piece that the shift pointer slides over. 15. SOLD 16. Complete set of original 69-70 emergency/parking brake cables. They are in working condition but have surface rust on the outer housings. The inner cable is not rusty and works slides fine. The rubber insulator sleeves are cracked and will need to be replaced. 17. 69 coupe/convertible mustang original glue in clear passenger door glass- has damage at the bottom where an idiot tried to clean the glue off with a wire wheel but it is below the door line and should not be visible when installed. It also has a small sliver missing along the back edge but will be covered by the vertical trim when it is put on and not seen. Other than that it is in good condition with only minor surface scratches. Vertical trim NOT included 18. 69 coupe/convertible mustang original glue in clear drivers side rear quarter window. May have a few minor scratches but other than that good glass. 19. 69 coupe/convertible mustang original glue in clear passenger side quarter window. May have a few minor scratches but other than that good glass. 20. SOLD 21. 69-70 mustang original dash pad. This pad is in good condition and is complete. It did have one crack at the edge of the speaker hole and a crack on the passenger side edge but both have been repaired and look decent. 22. 65-70 mustang original power steering slave cylinder. It has been rebuilt with And is ready to install. This is an original BENDIX parts with correct stamping not cheap reproductions. 23. 67-70 mustang original power steering control valve. It has been gone through and rebuilt with all new components. This is an original BENDIX part with correct stamping not a cheap reproduction. 24. 67-70 mustang original power steering pump. Comes complete with pulley and rebuild kit. I have 2 of these available. 25. SOLD 26. SOLD 27. SOLD 28. 67-70 mustang original power steering pump adjuster bracket. This part has been cleaned and refinished in a satin black finish. 29. SOLD 30. 67-69 mustang original non greasable tie rods. These are in good condition with no internal rust and they function as they should with no slop. I have both inner and outer tie rods available. 31. 69-70 mustang original power steering pump index hose bracket for a 302 or 351w. This is the bracket that attaches to the back of the power steering pump and helps support the hoses. 32. 69-70 mustang original engine crossmember. This part is in nice condition and has been refinished in a gloss black finish. 33. 69 mustang NEW tail light bezel trim rings. This is the trim that goes along the outer edge of the raised portion of the tail lights. These are new and unused. This is for a complete set of 6 which is enough to do both right and left lights. 34. 69 mustang original rim blow steering wheel. It is a complete wheel with the center pad and trim, center emblem and a NEW rim blow switch. It has had all the cracks repaired and has been primed. 35. 69 mustang original standard interior steering wheel. This wheel has been restored and has a black finish. It is a complete wheel with the center pad and the horn ring. 36. 71-73 mustang original sport mirror seals. 37. 69 mustang original chrome remote mirror seal. 38. SOLD 39. SOLD P 40. 69-70 mustang original disc brake caliper stabilizer bracket. 41. 69-70 mustang non ac, heater blower switch resistor. 42. 69-70 mustang original AC heater core foam insulator end caps sill nice and soft. Has correct c9z part # molded into it. 43. SOLD 44. SOLD 45. 70 mustang dash lighter bezel original 46. 69-70 mustang original wiper washer bezel with hard to find wiper switch spacer 47. SOLD 48. 69-70 mustang center console rear ash tray insert original. 49. 70 mustang seat belt shoulder harness anchor bolt covers NEW. 50. SOLD 51. SOLD 52. 65-73 mustang wiper washer pump, originals but missing propellers working condition 53. 69-70 mustang original hood hinge springs par. They have surface rust but will clean up nice. 54. SOLD 55. 69-72 window crank original 56. SOLD 57. ford 9" 28 spline axles matching pair 58. SOLD 59. 68-70 mustang seat hinge covers. Several available. 60. 69-70 mustang sport roof / mach 1 pass side quarter window glass channel with pivot and mounting hardware. Has some pitting on the chrome but is usable. 61. SOLD 62. 69-70 mustang sport roof / mach 1 original quarter window handle strikers. They have some window adhesive on them and have a few minor scratches but should clean up nice. 63. 69-70 mustang bucket seat original fold down release levers. 64. 69-70 mustang original clutch pivot frame bracket. Edited December 15, 2014 by Kris Quote Share this post Link to post Share on other sites
DragPack69 0 Report post Posted September 6, 2014 Kris, PM sent. John Quote Share this post Link to post Share on other sites
rodbrady 18 Report post Posted September 7, 2014 pm sent. Quote Share this post Link to post Share on other sites
Kris 90 Report post Posted September 7, 2014 Pm's sent Quote Share this post Link to post Share on other sites
stuart 13 Report post Posted September 10, 2014 Sent you a PM. Stu Quote Share this post Link to post Share on other sites
Kris 90 Report post Posted September 10, 2014 pm sent Quote Share this post Link to post Share on other sites
murphsmustangs 10 Report post Posted November 25, 2014 Do you still have your 69 non ac blower motor resister? Quote Share this post Link to post Share on other sites
shelbyshelby 52 Report post Posted November 25, 2014 Price of # 8 and 2 of #38. Quote Share this post Link to post Share on other sites
stangman68 95 Report post Posted November 25, 2014 Interested in horns, if U still have....pls PM. Quote Share this post Link to post Share on other sites
Kris 90 Report post Posted November 26, 2014 Yes I still have the blower resister. Pm's sent on the others and updated parts list. Quote Share this post Link to post Share on other sites
stuart 13 Report post Posted November 26, 2014 Stu Quote Share this post Link to post Share on other sites
murphsmustangs 10 Report post Posted November 27, 2014 I would like to buy your heater 69 heater resistor. Call me @ 541-788-0518 Mike Quote Share this post Link to post Share on other sites
DarkBuddha 107 Report post Posted November 27, 2014 PM sent. Thanks. Quote Share this post Link to post Share on other sites
RPM 1,190 Report post Posted December 3, 2014 Hey Kris, I'm looking for item #9, driveline for a 351w, fmx, 50-5/8" u joint center hole to center. Bob Quote Share this post Link to post Share on other sites
70769 18 Report post Posted December 8, 2014 got my part today. thanks kris! Quote Share this post Link to post Share on other sites
rodbrady 18 Report post Posted December 9, 2014 pm sent Quote Share this post Link to post Share on other sites
DarkBuddha 107 Report post Posted December 9, 2014 I got my parts from Kris today. Exactly as represented and described. Thanks Kris. Quote Share this post Link to post Share on other sites
starman 0 Report post Posted May 7, 2016 Need more info on what driveshaft fits, still got hood hinge. and still have the dash, need one to mount my cover on. Quote Share this post Link to post Share on other sites
Kris 90 Report post Posted May 7, 2016 All those parts are sold. Quote Share this post Link to post Share on other sites