hawkdriver 14 Report post Posted November 14, 2013 Hey, Im installing a Hayden 3654 setup controller to my taurus fan, i do not have A/C. I once read that this 'green A/C clutch" wire from the controller could be used as an under dash override in the event of temp sensor failure. Can anyone confirm this and explain how i would wire this up. I pressure i need a 12+ source and to extend this green wire to a switch and to ground out the switch. Where can i easily pull 12+ from in the cabin of fuse box? Thanks for your help. Quote Share this post Link to post Share on other sites
magician 13 Report post Posted November 14, 2013 (edited) Yes that should work..I did it on mine...you can catch the cig lighter to get 12v.I have an Under hood fuse block to handle all my add on's. DON'T ground switch.just use it interrupt.green wire. Edited November 14, 2013 by magician Quote Share this post Link to post Share on other sites
hawkdriver 14 Report post Posted November 17, 2013 How did you wire up that fuse block i have been seeing that and would like to give it a try? Quote Share this post Link to post Share on other sites
magician 13 Report post Posted November 17, 2013 I got one out of a crown vic in the junk yard.pulled it apart,traced the wires and spliced into them..it has about 8 fuses and 4 relays in it. I'll see if I can get pix. Quote Share this post Link to post Share on other sites
magician 13 Report post Posted November 18, 2013 Quote Share this post Link to post Share on other sites
