bomccorkle 12 Report post Posted December 12, 2012 Has anyone for a lack of a better phrase found a better way to mount an e brake. For example has anyone used maybe a Corvette style That's tucked down near the floor next to the door? Was thinking that may be a swell solution to the factory routing. Quote Share this post Link to post Share on other sites
mcgirr455 10 Report post Posted December 12, 2012 I used a tunnel mount style from a 91 Accord in my 65 mustang. A little reinforcement and the cables hooked up to the Ford backing plates. Works great but not with a factory console. Quote Share this post Link to post Share on other sites
MustangChuck 16 Report post Posted December 14, 2012 I think I know what you are talking about with the Corvette handle. It sits between the driver's seat and the door, correct? Getting the cables to work might be a challenge, unless you can also scavenge all of the Vette's chassis brackets. I am planning to pull the hand brake from my 94 donor car and install that. I haven't started and it definitely won't work with the stock 69 console. I also have the 94's console and will look at it, but I doubt I will be able to do much with it. Chuck Quote Share this post Link to post Share on other sites
bomccorkle 12 Report post Posted January 10, 2013 That's it chuck. Sorry I've gotten busy with other stuff but I'm not gonna use a console anyways. Maybe I'll just hafta look see what I can find. Quote Share this post Link to post Share on other sites
Boogerschnot 12 Report post Posted January 12, 2013 If you figure out the 94new brake handle, let me know.. I used a 93dynamat console, cut the inner braces and reshaped it with a heat gun. The guy i got it from gave me the brake handle and intermediate cable /connector too. Just need to figure it out. Heres the console. I really just wanted something to put a drink in and reat my arm on. Quote Share this post Link to post Share on other sites
Boogerschnot 12 Report post Posted January 12, 2013 Damn spellcorrect on my phone.... PITA. Quote Share this post Link to post Share on other sites
MustangChuck 16 Report post Posted January 12, 2013 Your 93dynamat console looks identical to the 94-98 console. For the hand brake, there are also a mounting plate and cable guides from the trans tunnel that are necessary. Both can be fabricated. I've been told that it's pretty simple, once you've measured everything. Since you don't have the measurements, I'll provide them once I take them. (It may be a while, so please don't hold your breath.) Chuck Quote Share this post Link to post Share on other sites