SpadzSaleen 10 Report post Posted September 18, 2010 Hey Guys, Just a couple quick questions on converting my car from a FMX transmission to a 4 speed top loader. I have all the linkage in the car with the clutch pedal, now with the center console out of my car, is the hole where the automatic shifter big enough for the top loader or is it too big?? I have no clue what to expect. The console i have is for a manual so im not worried about that. Its the actual hole thats in the floor? And also, is the driveshaft the same for an FMX and 4 speed toploader?? Thanks guys! Quote Share this post Link to post Share on other sites
royclore 10 Report post Posted September 19, 2010 I did this years ago and didn't have to touch the floor. The hole is the same for both. Make sure you have the correct toploader as far as where the shifter is mounted. I was able to use my driveshaft too. Roy Quote Share this post Link to post Share on other sites
brandon mitchell 10 Report post Posted September 24, 2010 I agree on what you are up to. It's boring to drive automatic transmission cars don't you think? Quote Share this post Link to post Share on other sites
LoneWolf2U 136 Report post Posted September 24, 2010 The floor hole is fine for eather auto or manual, its the correct shifter for the mustang you need to find. Quote Share this post Link to post Share on other sites
