Rich Ackermann 174 Report post Posted May 12, 2023 Maybe you already seen this aftermarket part from Tinman. I just learned of it, so It thought I'd pass it along. https://www.tinmanfabrication.com/products/mustang-convertible-crossover-drive-shaft-loop-1965-1972 1 Grabber70Mach reacted to this Quote Share this post Link to post Share on other sites
Vicfreg 771 Report post Posted June 7, 2023 Wow, interesting. Would like to see it installed with the pipes. The driveshaft safety loop is a nice touch. Pics of my 2-1/2" exhaust on my convertible, it is VERY tight. It was only possible because Mike (Latoracing) did his magic and somehow got the pipes through there.... 1 Rich Ackermann reacted to this Quote Share this post Link to post Share on other sites
427Stang 23 Report post Posted June 8, 2023 Modified my plate with sections of pipe to clear. 3" all the way out. 3 Rich Ackermann, bigmal and Grabber70Mach reacted to this Quote Share this post Link to post Share on other sites
Vicfreg 771 Report post Posted June 8, 2023 Wow, that is incredible... your workmanship and fabrication skills are to be envied. I like how you integrated the exhaust cut-outs.... Quote Share this post Link to post Share on other sites
427Stang 23 Report post Posted June 9, 2023 Thanks, the toughest part was fabricating the exhaust pod in the rear. the stock Shelby pod is a massive restriction to flow. 1 Grabber70Mach reacted to this Quote Share this post Link to post Share on other sites
Vicfreg 771 Report post Posted June 9, 2023 Wow, impressive. Yeah, you almost need an "X" pipe at the rear. The resonators are a nice touch. It should sound insane.... Quote Share this post Link to post Share on other sites
Vicfreg 771 Report post Posted June 9, 2023 My convertible is in the paint shop, check out my 1970 convertible thread. Quote Share this post Link to post Share on other sites
