69 Fastback Engine Compartment Photos

[Black Jade 43]

Working on tidying up engine compartment, need pictures of hood scoop turn signal wiring. More specifically from front harness plug around master cylinder to where the wiring runs and fastened to underside of hood to where the bulb sockets plug into scoop turn signal housings. Ed 

[TexasEd 188]

Here are some before I took it apart.  I don’t know if it’s perfect  

[TexasEd 188]

[Black Jade 43]

Thanks Texas Ed, that helps a lot. The factory harness was shot, bought alloy metal products, didnt think to take pics before I took old one off. Ed.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

[stangs-R-me 120]

Here is a picture of a low mile original Mach 1 hood scoop wiring at the firewall.   It does not show the wiring at the scoop and since the car has the factory underhood pad in place it would not be visible anyway.

And two more pictures showing how I have it on my car where I tried to duplicate the factory routing and hardware as best I could.   

The main variance from stock is the Zinc/Rubber coated clip holding the harness to my hood is incorrect ... the correct clip was black plastic and taped to the harness with friction tape and is not being reproduced and difficult to find used.

Doug

 

[stangs-R-me 120]

Here is a picture of the page out of the 1969 Mustang Osborne Electrical Assy showing the hood turn indicator installation, wiring routing, and hardware.

As well as 2 pictures of a NOS factory harness currently on ebay that has this rare black plastic retaining clip taped onto the harness.   

If you have a spare $995 laying around (plus $21.95 shipping) it could be yours !!   

Not my listing, nor do I have any affiliation with the seller.

Doug