potato 10 Report post Posted November 17, 2022 My car's gas tank was replaced by a previous owner. It appears they did a couple things wrong. The filler neck is not fed through the taillight panel correctly so the gas cap doesn't fully tighten. Inside the trunk smells a bit like gas, like the filler neck is not sealing up to the tank. Under the car, it has developed a slow dripping gas leak around the rubber line coming from the sending unit. So anyways, I'd like to redo both the filler neck and the sending unit. Is there a diagram of the way those 2 parts are assembled? And what all seals and rubber parts would I need to do it all at once? Quote Share this post Link to post Share on other sites
Mach1 Driver 603 Report post Posted November 17, 2022 https://www.npdlink.com/product/seal-fuel-tank-sender/106862?backurl=search%2Fproducts%3Fsearch_terms%3Dseal%252C%2Bfuel%2Btank%2Bsending%2Bunit%26top_parent%3D200001%26year%3D1969&year=1969 https://www.npdlink.com/product/hose-fuel-tank-filler-tank-to-pipe/150123?backurl=search%2Fproducts%3Fsearch_terms%3Dfiller%2Bneck%2Bhose%26top_parent%3D200001%26year%3D1969&year=1969 https://www.npdlink.com/product/fuel-hose-kit-concours-gas-ssnn-and-gas/106894?backurl=search%2Fproducts%3Fsearch_terms%3Dhose%2Bfuel%2Bline%2Bto%2Bsender%26top_parent%3D200001%26year%3D1969&year=1969 https://www.npdlink.com/product/gasket-fuel-tank-filler-to-panel/106709?backurl=search%2Fproducts%3Fsearch_terms%3Dgasket%2Bfuel%2Bfiller%2B%26top_parent%3D200001%26year%3D1969&year=1969 2 potato and RPM reacted to this Quote Share this post Link to post Share on other sites
TexasEd 205 Report post Posted November 25, 2022 The sending unit is hard. I installed one in a tank before I put it in the car and it was difficult. Doing it under a car is harder. I developed a leak the second time I worked on the sending unit while the tank was in the car and made a huge mess. The hard part is keeping the flat washer flat as you place the sending unit on it and then tighten down the pressure ring. If you can do it out of the car I recommend that. A little petroleum jelly on the washer also helped to keep it in place. Quote Share this post Link to post Share on other sites
RPM 1,258 Report post Posted November 25, 2022 I guess I got lucky installing my fuel sending unit. It went in easy peasy and didn't leak. Yet... 3 Caseyrhe, Brian Conway and Grabber70Mach reacted to this Quote Share this post Link to post Share on other sites
