RPM 1,190 Report post Posted August 8, 2022 A couple of questions for you know it alls. What, if anything do y'all use to secure the flex duct to the hard plastic ends. I sure don't want it coming loose one installed. Is the piece with the dip in it in the pic with the X in the proper orientation? All the pics I've seen show it with the V pointing down. But with it in that position I can't get the alignment with the elbow to its left lined up perfectly. EDIT: Is any fastener used where the elbow tube that connects to the vent and to the tube with the drop down bend in it? Thanks guys. Quote Share this post Link to post Share on other sites
Mach1 Driver 560 Report post Posted August 9, 2022 Jiminy! Sorry, no help here 1 RPM reacted to this Quote Share this post Link to post Share on other sites
stangs-R-me 120 Report post Posted August 9, 2022 Just looked through all my pics from when I had my dash apart in 2011 and did not find any with the ducts in place. I don't remember any type of clamps holding the hoses to the plastic pipes though ... pretty sure they were just slip fit and stay in place because they are relatively short and captive between fixed points. Doug 1 RPM reacted to this Quote Share this post Link to post Share on other sites
RPM 1,190 Report post Posted August 10, 2022 Thanks Doug for looking, and Terry for the chuckle. I'm probably over thinking it, but I seem to remember removing staples from the hard plastic tubes that secured the flex tube. Champagne problems. Quote Share this post Link to post Share on other sites
stangs-R-me 120 Report post Posted August 10, 2022 Guessing you are probably right about the staples ... that would make sense. I should have a spare set of ducts at home that I could check but I'm out of town at the moment. Doug 1 RPM reacted to this Quote Share this post Link to post Share on other sites
RPM 1,190 Report post Posted August 11, 2022 Thanks Doug. Quote Share this post Link to post Share on other sites
Caseyrhe 650 Report post Posted August 13, 2022 The 68 and my 69 had tape holding it on 1 RPM reacted to this Quote Share this post Link to post Share on other sites
stangs-R-me 120 Report post Posted August 14, 2022 The one end of of each hose has 2 staples holding them to their duct pipes. Looked under my dash and could see and feel the pipe with the kink in it ... the kink goes down to clear the speedo cable that goes above it. Only evidence of tape I see is at the far end elbows that attach to the dash vents (passenger side elbow is not shown as is still attached to my spare lower dash). I see no tape residue present where the hoses slip over the two ducts, so at least ways on my Metuchen built (& the spare Dearborn built) the hoses appear to have been just slip fit at these two points. Doug Quote Share this post Link to post Share on other sites
RPM 1,190 Report post Posted August 14, 2022 Thanks Casey and Doug, I do appreciate your time. 1 stangs-R-me reacted to this Quote Share this post Link to post Share on other sites