Door Frame windlace that covers the fiberglass panels

[TexasEd 188]

Need confirmation that I have this upside down and wrong side.  When I close the door it pushes the windlace off the body panel.  Anyone got a photo of it properly installed?  My old ones were so bad I did not get a good idea.

[TexasEd 188]

Figured out it is on the correct side but the flat flap goes under the fiberglass. Does this look correct?

 

[Ridge Runner 1,112]

One end of it should have a slight curl to it ,that end goes up ,the flap goes under the fiberglass

[Brian Conway 264]

Any help?  Brian

[Len69Coupe 33]

Looks like you're missing the screw in the top of the windlace. Something else doesn't look right. Looks like you don't have the top of the panel edge slid down into the window channel. That should bring the panel tighter to the windlace.

[TexasEd 188]

11 hours ago, Len69Coupe said:

Looks like you're missing the screw in the top of the windlace. Something else doesn't look right. Looks like you don't have the top of the panel edge slid down into the window channel. That should bring the panel tighter to the windlace.

The panel was not tightened down during that, I was test fitting it.  Yes, I am missing the screw.  It looks better with the panel screwed down, the bottom is still a mess.

Anyone have a pic showing how it fits under the sill plate?