Wire Clip

[jrw69 16]

Is there a way to remove the wire loom clamp that holds all the wires to the alternator and wire harness? I need to clean up and rewire some  wires.  This is just below the solenoid and voltage regulator.I can cut it out but would like to reuse if possible  

 

Thanks

[Brian Conway 264]

These?

[jrw69 16]

Hi Brian

Exact location, but these are different. My electrical assy book shows it as a wire loom clamp # 382184-S. Pics aren't great but the clamp has the wire going through it. I have a 69 Mach with 351W from Dearborn so maybe they used different clamps. Doesn't appear to have a way to squeeze or pry it off to get the wiring out.

[Brian Conway 264]

OK. Not familiar with that set up.  Brian

[Midlife 814]

That's a factory molded crimp; shouldn't have a part number associated with it, as it is molded into the wire harness itself.

[jrw69 16]

Thanks Midlife

May leave it alone rather than try to remove it as it may cause more problems.

 

[jrw69 16]

Midlife

Follow up question

Can I cut this clip out so to get to the wires? Some have lost the covering and need to be replaced. Once this clip is off I  can repair or replace them.

 

 

 

 

Thanks

[Midlife 814]

I've removed the molded cover a couple of times.  Just be careful with a knife and don't nick the wires.

[jrw69 16]

ok will do that,

Thanks Midlife