Her69fastback 2 Report post Posted May 9 To all the wiring gurus. I have everything wired & to car runs. I’m trying to figure out the double fan wiring. I have 2 relays on the way. I have 2 electric fans. The Holley snipe will control the fans. What’s confusing me is they say the Light blue & light green wires are output connect to relay ground trigger. I’m a dummy when it comes to wiring. I have searched the wed & it’s more confusing. I found this pic & I think this is how I need to do it. I want someone that’s knows a lot more then me to look at it. Quote Share this post Link to post Share on other sites
det0326 124 Report post Posted May 9 12v to one side of relay coil and the sniper signal simply grounds the other side of coil. Doesn't your instructions show u how to connect I know the fitech does. Quote Share this post Link to post Share on other sites
aslanefe 251 Report post Posted May 9 Looks correct to me. Quote Share this post Link to post Share on other sites
Mach1 Driver 418 Report post Posted May 9 Yes its correct, the Sniper instructions say the blue and green wires from the 10 pin plug go low (go negative) when turned on. These wires go to 85 which is one side of the relay coil, and 86 is the other side which goes to battery +. That operates the relay and 30 to 87 closes applying battery + to the fans, the other side of which goes to chassis. Quote Share this post Link to post Share on other sites
Her69fastback 2 Report post Posted May 9 Thanks for all the help Quote Share this post Link to post Share on other sites