Her69fastback 3 Report post Posted February 27, 2022 I’m replacing all the gauges with Autometer gauges. What should I do with the gauge block that plugged into the old gauge cluster? Tape it up, cut it out or something else? Quote Share this post Link to post Share on other sites
Midlife 814 Report post Posted February 27, 2022 If you are not using the old circuit card, then this connector is pretty much useless. The wires going into it will form many of the wires needed to wire the aftermarket gauges, along with many others. What ever wires are left over, please protect them from shorting against any metal. Quote Share this post Link to post Share on other sites
Mach1 Driver 560 Report post Posted February 27, 2022 There are a few things you probably still need. This is for a non-tach dash: tach dash: BTW, if you need to delete the flex circuit, Mid makes wires to replace it. I suspect he would be happy to supply what you need. 1 RPM reacted to this Quote Share this post Link to post Share on other sites
Her69fastback 3 Report post Posted February 28, 2022 Thanks for all the help Quote Share this post Link to post Share on other sites