Quarter Window Upper Pivot Rod and Lower Sleeve

[Gray69 5]

Does anyone know of a source for the upper pivot rods and the lower pivot rod sleeves? I actually have the upper pivot rods but do not have the thin metal piece that it is screwed to. Found Scott Drake includes them in a complete assembly but I have the other components so don't need the entire assembly. Also looking for the lower sleeves/bushings if someone has a source for something that can be used in place of those. 

Thanks in advance.

Matt

[RPM 1,190]

I made two out of milk carton plastic. I used a heat gun to form the plastic around shaft. 

[aslanefe 333]

36 minutes ago, RPM said:

I made two out of milk carton plastic. I used a heat gun to form the plastic around shaft. 

Did you use 2% or whole milk jug? :)

[RPM 1,190]

Full power only in my house. 2 percent has too much sugar added. Although I'll eat a half gallon of ice cream in one sitting. 

[Caseyrhe 650]

I used a Whataburger straw on the lower

[Midlife 814]

14 hours ago, RPM said:

Full power only in my house. 2 percent has too much sugar added. Although I'll eat a half gallon of ice cream in one sitting. 

Wimp!  I'll tackle a full gallon at one sitting. 

[Mach1 Driver 560]

Ice cream headache!

[RPM 1,190]

3 hours ago, Mach1 Driver said:

Ice cream headache!

But it hurts so good. 

[Gray69 5]

Not in Texas, so no Whataburger here in Central AR though they have them in NWA now. For the lower plastic bushing, found that the pump tube in my wife's shampoo bottle fits perfectly and is slighter thicker than the original. Going to be funny to watch her confusion when a half full bottle stops delivering shampoo. :)
 

For the upper rod, I will make a spacer for it.