albanygt40 0 Report post Posted December 11, 2021 Hi I have a 70 Mustang fastback and the previous owner fitted a custom cross member and shock tower delete plates. Im looking to put the car back to stock. Im hoping someone can PM or link me to a good measurements page so I can the stock towers in the right place. Cheers Quote Share this post Link to post Share on other sites
Ridge Runner 1,112 Report post Posted December 11, 2021 Oh ,that may be a job! I believe there is plates welded over the frame rails you will have to remove . Under those plates on the frame rail you will find alignment holes ,the new towers from Dynacorn also have these holes ,a bolt or dowl through the holes and that is where it goes . You will need the measurement between the upper control arm bolt holes but we can get that to you soon as you are ready for it Quote Share this post Link to post Share on other sites
Ridge Runner 1,112 Report post Posted December 11, 2021 Some pics of the alignment holes on the original towers ,upside down because the car is on my rotisserie . Pardon my pointer haha Quote Share this post Link to post Share on other sites
Ridge Runner 1,112 Report post Posted December 11, 2021 There is also a place on the bottom of the frame rail where the tower over laps the frame ,there is a hole that centers over the spreader bar bolt hole Quote Share this post Link to post Share on other sites
albanygt40 0 Report post Posted December 12, 2021 Thank you , awesome. Hopefully mine has the holes still. Quote Share this post Link to post Share on other sites
Midlife 814 Report post Posted December 12, 2021 You can also use the export bar/brace to help align the tops of the shock towers. Quote Share this post Link to post Share on other sites
Rsanter 152 Report post Posted December 13, 2021 I have a whole front clip if you needed it, should yours be too modified from the conversion Quote Share this post Link to post Share on other sites
