JR69 0 Report post Posted November 12, 2021 Hello everyone- I'm looking for some input on alignment issues with my 69 Mustang Fastback. Passenger side is all set, however, the drivers side is not sitting correctly. I did adjust the center link, tie rods and strut but still cannot pin point what is causing the negative camber. Someone did say that the eccentric would have to be adjusted, while another said to put shims under the upper control arm. Any input is greatly appreciated. Quote Share this post Link to post Share on other sites
Boss429Dreamer 18 Report post Posted November 12, 2021 Camber is adjusted via the eccentric on the lower control arm on a '69. But I am far from an expert on alignment. Quote Share this post Link to post Share on other sites
aslanefe 333 Report post Posted November 12, 2021 You can adjust with eccentric, and if you run out of eccentric adjustment, you can shim upper control arm. 1 RPM reacted to this Quote Share this post Link to post Share on other sites
JR69 0 Report post Posted November 13, 2021 Thank you! Quote Share this post Link to post Share on other sites