EastYorkStang 63 Report post Posted August 28, 2021 Found out my nozzles are plugged. Put them in CLR for now What have you done to unplug them ? Quote Share this post Link to post Share on other sites
Kris 90 Report post Posted August 28, 2021 Take them off and run a piece of welding wire through them. Then blow out with an air hose. 2 Caseyrhe and dmck reacted to this Quote Share this post Link to post Share on other sites
Vicfreg 771 Report post Posted September 18, 2021 Vinegar 1 Caseyrhe reacted to this Quote Share this post Link to post Share on other sites
EastYorkStang 63 Report post Posted September 20, 2021 On 8/28/2021 at 5:21 PM, Kris said: Take them off and run a piece of welding wire through them. Then blow out with an air hose. Thanks, did almost that. Ran some 18 gauge wire through them. Then the pump stopped working. Quote Share this post Link to post Share on other sites
Caseyrhe 650 Report post Posted September 20, 2021 Take the hose loose from the tee above mst cyl and see if it’s pumping to there. do you have power to the pump? pump can be swapped out in lieu of buying entire washer bottle. Quote Share this post Link to post Share on other sites