Rcodenewf 44 Report post Posted August 19, 2021 A couple of the rubbers were missing from the window limiting stops so i went and bought a selection of vacuum caps at my local supplier. After matching the cap to the bracket i sprayed it with a little silicone and then warmed it with my heatgun. They fit quite tightly as the heat allows it to stretch and then constrict when cool. Probably will outlast the car. In the pic the original is in the middle and the ones on either side of it are the ones i did. . In my opinion its better than wrapping tape around it. Hope this helps someone who runs into this situation. John 4 Lateral_Line, RPM, 69RavenConv and 1 other reacted to this Quote Share this post Link to post Share on other sites
Midlife 814 Report post Posted August 20, 2021 Great thinking! Quote Share this post Link to post Share on other sites
Rcodenewf 44 Report post Posted August 20, 2021 Thanks Midlife. We're always searching for simple solutions to our mustang problems. Regards....John Quote Share this post Link to post Share on other sites
EastYorkStang 63 Report post Posted September 8, 2021 What do these limit, the up or down movement ? My 70 has rubber blocks the stop the downward motion Quote Share this post Link to post Share on other sites
Rcodenewf 44 Report post Posted September 10, 2021 These are the upper stop limit brackets. ..John Quote Share this post Link to post Share on other sites
EastYorkStang 63 Report post Posted September 13, 2021 Gotcha, ok, thanks! Quote Share this post Link to post Share on other sites
jjstang 51 Report post Posted November 30, 2021 Ah, the mother of all invention....... good job Quote Share this post Link to post Share on other sites
Rcodenewf 44 Report post Posted December 1, 2021 Thanks jjstang. I figured i'd give it a shot and it works well. Regards...John Quote Share this post Link to post Share on other sites