tom C 0 Report post Posted July 16, 2021 Hello, I have a question about the latches for the fold down seat, I'm installing it now and noticed that the latches have to be screwed down to the bracket before you put the rear inner quarter panel on, however when I installed the latch and put the quarter panel trim on it covers the four little screws that adjust the latches in and out. Im not sure if the aftermarket {crap} panels are missing holes on the top for the adjustment or if Im just stupid. Any help would be appreciated, Thank you in advance. Quote Share this post Link to post Share on other sites
Brian Conway 264 Report post Posted July 16, 2021 Pictured is an original panel and yes no access holes. I measured the back seat to get an idea of where the bracket should mount. Also a ' dry fit ' to make sure the post would not contact the very thin fiberglass post opening. Brian 1 Caseyrhe reacted to this Quote Share this post Link to post Share on other sites
Dave R. 85 Report post Posted July 17, 2021 And if your back seat doesn't rattle as you drive call the cops. Someone has stolen the seat. Dave R. 3 Midlife, Mach1 Driver and Caseyrhe reacted to this Quote Share this post Link to post Share on other sites