Search the Community
Showing results for tags 'trans'.
Found 3 results
-
I have a 69 Mach 1 with a 351 and was wondering if anyone can suggest a throttle assemble with a Edlebrock carb 1412 and Edlebrock Torker intake either stock or aftermarket set up. Will a stock bracket work on a Torker manifold. Also I cant find a mounting bracket for the toploader shifter that will fit. It is a 433 trans with the long housing. The brackets on the internet are too short. The trans is a RUG AV. Any help appreiciated. Thanks
-
Hello To All, After driving the car for more than an hour, when I come to a stop and get ready to go again I have to bump the gas in order for it to engage or loosen up. Any ideas? Pigbait69
-
Looking for some help. I just replaced the transmission cooler lines, but I can't figure out the connection at the radiator end. At the trans end of the lines, like the original set, there are male connectors, which work fine... BUT as you can in the pic below, there's only a female connector/nut at the other end of the lines to meet up with the likewise female rad connector. Why didn't it have a male connector at both ends? Any suggestions? I assume I can find the right hardware, but I thought this was a fairly universal connection. I'm missing something obvious or the part came to me set up improperly. EDITED by GnarlsDarwin, on Flickr