Search the Community
Showing results for tags 'tach dash'.
Found 2 results
-
Hello to all, I have the direct fit performance gauges. The issue is my high beam indicator (led) is lit through the tach. When the car is running and I hit my high beam the tach needle will jump up to 3500 and then settle at 1500. The engine will never rev during this even though the tach indicates this. I have it wired up as instructed. Any ideas? Pigbait69
- 5 replies
-
- electrical
- gauge
-
(and 2 more)
Tagged with:
-
that were cut and taped under the dash. Being partially colorblind makes it tough, but it looks like they belong in the moon shaped plug that goes to the column. Would having any wires there cause the gauges not to work? I bench tested and all respond fine (tach dash), but plugged in I have nothing but lamps and the pass side blinker light (left side works, but the arrow doesnt light up. Poss related or not related is that my brake lights dont light up...switch is good and plugged in. all park lights work fine, as do the turn signals. Looking at the pins, the last 3 on the inside are not plugged in. On a tach dash, are the holes all used or are some not? I will post pics of colored wires, son said they are different colors of green, light and a dark, one with what looks like a white stripe, and a tanish one. Do they make the pins, or should i just wire outside of the plug? I did search and read about 30 posts on this subject, but with a tach dash it seemed to not apply to most, and others had issues with the pod not working which is not my issue, it works fine outside of the car. Thanks!!