Search the Community
Showing results for tags 'sleeve'.
Found 1 result
-
I have pulled the front strut rod (drivers side) on my 69. When I followed the shop manual, it said to pry the forward washer forward with two 18in pry bars on either side to "separate the inner sleeve from the outer sleeve". My parts are all original (I believe), and these sleeves were stuck so bad that I pulled the flange of the inner sleeve through the hole in the forward washer. See pic. No big deal really since I have a rebuild kit. However, the rebuild kit I have doesn't use the inner/outer sleeve design. My new kit has a single "fairly thick" sleeve, 2 bumpers, 2 washers - but only a single piece that could go on either the front side of the frame hole, or the back side. The pic shows this configuration. There are no instructions with the kit. Does it even matter which side I put the "frame washer" (for lack of a better word)? Let me know if anyone has any idea how this is supposed to go... Thanks, Jay
