Jump to content

J's69Mach1

Members
  • Content Count

    192
  • Joined

  • Last visited

About J's69Mach1

  • Rank
    1969 Mach 1
  • Birthday 06/05/1972

Profile Information

  • Gender
    Male
  • Location
    Fresno , California
  • Interests
    Mustangs and Fords,

Converted

  • Biography
    Married , w/3 kids
  • Location
    Fresno, CA
  • Interests
    Mustangs
  • Occupation
    School Grounds Worker

Recent Profile Visitors

1,056 profile views
  1. With several choices, If you pick 1 TKX, which one would it be and why ? They have a TKX with 2.87 first gear, along with the .81 5th gear. listed as more for Road Race.
  2. I just found out yesterday they came out with the New TKX transmission same as the TKO600 but slimmer tighter case made just for the Classic Muscle Cars/ Hot Rods. I notice they have several choices for our Fords. Nice!
  3. I think Aslanefe is right , they look like a Drum Spindle with a Bracket and possibly a Older Master Power Disc Brake conversion kit which use Like 85 Cadillac Deville (Or a similar GM)front calipers. i have a similar kit on mine.
  4. Any noise coming from the alternator bearing ? Where pulley sits there should be a spacer also, I am Just saying ideas.
  5. I very much like mine , it was Manual Steering before. Now steering is smooth , steers straight and i can easily Do turns 1 handed now . I got it thru Summit with a Saginaw Pump , i know its the 85ish Toyota Cresida steering gear box they used For the conversion in my kit. I installed it Years back. I just wish their gear box would of been smaller for more header clearance . And their Hydraulic hoses in kit a bit longer. Other than that No Regrets yet. We are planning on doing a borgeson kit on my sons 66 Mustang sometime in the future.
  6. Welcome to the Forum. I did the T5 swap On my 69 Years back(like 10 years ago). I used 1 from a junkyard 90 Mustang V8 5.0 . The input shaft cone was broken all around the nose Which is common i guess if driven Hard, they were made of aluminum. I replaced with the Steel Ford Racing Cone. I went clutch cable on mine. Along with parts necessary The swap was easy and fit well almost like it was meant to be from the factory. T5 shifts like butter and absolutely love it but i never Really go hard on it from a dead stop. Great for Cruising and just Driving it , I wouldnt go T5 for launching from a dead stop . My engine is a Modded 351w . My plan is I will go TKO600 .82 final 5th gear along a hydraulic External slave in the years to come as i save up money for that Project . I have read (internet)that on a 69 the Tko600 clears the tunnel. Some say the TKO600 shifts smooth, Others say different.
  7. After numerous attempts, finally On mine i installed the grommet first onto the VC , then i pushed in breather with a touch of oil to slide in .
  8. Yes I had my son help and step hold brake pedal while I bled proportioning valve . I did it like 3 times with key switch on/engine off until light came off.
  9. West Coast Classic Cougar has instructions on how to bleed and turn off brake switch light on proportioning valve. It's under how to rebuild proportioning valve page on bottom . How to Centralize brake light switch piston position.
×
×
  • Create New...