So long story but here it is. I just purchased a 69 coupe that was completely torn down to a rolling chassis. The previous owner had purchased a new dash pad sometime over the last 5 years and let it sit. I purchased a new gauge bezel and have a factory passengers dash section. After installing the gauge bezel I started on the dash pad. I got it all in and bolted up but there is a small gap between the gauge bezel and the dash pad along the top edge. I tried prying, pushing, pulling, etc but cant seem to close the gap. There was the same issue on the passengers side panel where the clock is. Is this the dash pad being old and tweaked from sitting wrong on is it just reproduction parts? Any ideas. It is not noticeable from outside or with a quick look inside but if your sitting in it driving it is annoying.