70Nightmare

I got the stang running and driving now and it feels good. Got to clean up the wiring and back to do some more bodywork on both quarters and taillight panel.

I have had to remove panels that i have replaced due to wrecks ,and it is not fun .You think a factory spot weld is hard to drill ,try a plug weld .

Nice

I sold nightmare to a buyer in the UK. Some of you guys that are in the UK might see nightmare. I bought 69 fastback that is pretty solid and which im not use lol most mustang I have owned I always had to do bodywork but not on this 1. HHere's what it comes with Jasper built 302 Cobra eng with C6 trans with many add ons, headers, Mallory ign, Edelbrock alum intake, Edelbrock 600 carb, 270 Crane cam, 355 gears, elec fuel pump, Magnum 500 wheels, stage 2 Flowmasters, eng and trans have less than 10k miles.
Here are some pics.

 

Dam she looks good.

Started rewiring my car on Friday. It took me about day to get out the old harness. I started in the trunk area since it's the easiest and worked my way to the front. I finished the rear and started routing the wires I needed thru the firewall. It's not hard to just tedious and time consuming.

I sold nightmare to a buyer in the UK. Some of you guys that are in the UK might see nightmare. I bought 69 fastback that is pretty solid and which im not use lol most mustang I have owned I always had to do bodywork but not on this 1. HHere's what it comes with Jasper built 302 Cobra eng with C6 trans with many add ons, headers, Mallory ign, Edelbrock alum intake, Edelbrock 600 carb, 270 Crane cam, 355 gears, elec fuel pump, Magnum 500 wheels, stage 2 Flowmasters, eng and trans have less than 10k miles.
Here are some pics.

 

Nice!!!! Any jealous co workers? Theirs usually that 1 guy that say he doesn't like the car from my experience lol.

After removing the r/s front inner fender panel revealed more rot to the front section of the shock tower upper flange. I cut a piece of metal to make a patch for it.

I got the rotted section of the rocker panel cut out. I had some "honey do" work that got in the way of my plans so I did not get time to finish grinding my rough cuts or weld in the patch piece.

Good job on the build

Great update!  Nice work!

lol on the pin holes. I plan on repairing it from inside the car. I guess I'll be the guinea pig on this 1.

Car is totaled...

Hey alittle update. Well I finally bought my house and got some what situated. So I started to tear down the front end of the 69 to clean it up,paint and replace some of the hardware. It seem like I might have to replace the cowl since I'm seeing some small pin hole but it's only on the passenger side the driver side is good. I was wondering how would you guys goes about replacing it. Should I replace the whole top part or just the passenger side. I will get a better pic of the damage area when I get home tonight.