CHUCK4850

Hi, I need a pair of original lower control arms, that are not pitted. Here in CT, everything is rusty. They might be pretty nice where you are. Chuck

I'm interested in the '69 center grille support. Can you send me a picture of it? Chuck

I would go with contact cement. Silicone is very acidic, even when cured, so it will corrode the copper strips over time. It will eat a hole through steel as well, so never use it to seal a windshield, either! Chuck

I just pulled my front suspension out of my '69, and found that I have a bad left spindle. Somebody must have one? Chuck

PM sent.

I'm still looking for one. Anybody have any leads? Chuck

It uses a higher output blower motor that was actually air cooled. A rubber hose went from the fan area back out through the firewall, and into the can of the motor. When you were in Power Vent mode, outside air was sent out the two center A/C ducts. According to my Marti Report, my car came with this option. Somebody swapped it for a standard heater at some point, because it's not in there now. It was probably ordered with that option only because you couldn't get A/C in a 428 4 speed car. Chuck

I'm still looking for a complete Power Ventilation heater assembly. Somebody must have one! Chuck

I'm looking for a complete 1969-70 Power Ventilation heater setup. For those that don't know, it looks like the standard heater, but the dash pad has the center A/C outlets, and the control has a "POWER VENT" position. Chuck

Dennis, I PMed you, and emailed you. Maybe it went to your spam folder? Chuck chuck4850@aol.com

I did find that one, while searching everywhere I could think of. I thought the price was kinda high, but I guess it is really rare. And, it's from a Cougar, so the dash vents, and the sleeve behind them is wrong for a Mustang.

I'm looking for a complete power ventilation system for my 1969 Mach 1. My Marti report says my car was built with it, but somebody removed it. Chuck 203-288-2769