bobh67

Can anyone give me or info for the width of the hood center painted wide stripe and other strips,widths (locations) on a 70 Boss 302 ?

I need someone with a 70 mustang that can measure (without the bezel/light in it )and give me the width & height of the factory rectangular cutout dimensionsoff the 70 rear 1/4 panel for the rear side marker hole size.

I am in need of a 1970 mustang shaker base (or will take the whole assembly) if you don't want to break it up bobjanhaverland@aol.com FOUND WHAT I NEEDED!!!

Did the 1970 Boss 302's have the individual mustang lettering on the trunk lid? And which antenna is correct for a 1970 rectangular base or round? The catalog vendors show both available.

No AC lines just some in dash duct work and the other items I mentioned I'm near Dubuque, Iowa

For Sale: 1969 glue-in clear door glass RH side for a coupe. Asking $25, Also lots of misc. 69-70 factory AC items such as AC dash control panel ,blower case with blower and lots more. Asking $135 all.

NOS lower grill leading edge (thin part similar to the hood lip) moulding for a 69 mustang all models Asking $65

I needed one of these last month, finally found one .Nice 1970 dash!

I have part 1 and part 3 for you ...bobjanhaverland@aol.com

Complete from waterpump back and from carb to pan. About 80K miles on it. Making room. Asking $175. Pick up only in eastern Iowa.(563)590-7999 Bob

Now we're talking. That is the one.. I'll get a hold of them and price that option Thanks!

That's exactly what I have and does NOT work The crossover part of this bracket that goes over to the rear RH carb stud hits the Holley rear large vacuum port.

Thanks Mike, I already bought the Spectre #2418 off E-Bay .It looks like it will do the job.I know what you meen about the clearance between the carb base and the bracket I can make that work. My BIGGEST concern was the dimension of the square linkage hole working on my stock 70 accelerator cable.Was that an issue?

Just purchased a new Holley 600. It has a large rear base mounted vacuum port. When I try to install my throttle bractet(the factory one that mounts to the 2 rear carb studs )it hits the vacuum port. Anyone have this problem? Do I have to modify the bracket? Is there another one available? Do I take out the rear vac. port? This can be done because there is another one in the 1" spacer directly below it? Any help?

C6 automatic trans. for a small block For New seals and gaskets. Asking $225. Prefer not to ship.Located in eastern Iowa.

For Sale: 1969 351W complete 2 barrell motor. About 80K miles on it. Should need a rebuild .Complete from air breather element to oil pan and from the waterpump back. Asking $425. Pick up only in eastern Iowa

For Sale NOS 69 mustang lip moulding front edge trim. This is the trim piece that is on the leading edge of the panel below the grill. In the Ford wrapper Part Number C9ZZ-8419-A. Asking $80