rchappelear

OBIHL3 is the model number

I have a Gentex Auto Dim mirror with Home Link This only needs threes wires to work. ground 12v switched / ignition 12v power These harnesses can be bought off ebay or is supply the factory Molex clip and you can make your own. $50 shipped Ryan

these are to attach the lower collar to the inner rod tube sorry dont' have a photo for you my column is getting painted right now.

yes they are for a 1969 fastback, not a coupe or a 1970.

i have a set of 69. i will upload a photo later today.

they both have pros and cons.. i went with dynamat on everything, then on the headliner i used dynamat, then their dynaliner 1/2 mat for added insulation before installing the headliner upholstery

Above glove box black clock delete panel sold.

strut rod end

PM sent

here are the small arm parts

my motor is out getting rewound right now and has the arm attached to it so i do not have that measurement for you. I do however have these attached

miketyler where did you purchase the flair tool at

How have you installed the "Hollow Rivets" used on the center console cigarette lighter chrome trim bezel? I see their is a clincher tool out their ($100), just seems that it should be easier and more cost effective another way

after 10 hour dry time, take a large sheet of paper and dump the remaining flocking material onto the paper. You can salvage this excess fiber for future use. I give a good pat to the back side of the part working on to get any additional loose fibers out. give it a feel! Nice little mod

So you know how all the modern cars have a velvet feel to the lining of the glove box and center console. Well the process they use is called Flocking, and use ion generator for application. I have found a product that works great and a fraction of the cost to add the velvet to our mustangs glove box. I cleaned the glove box lining and center console lining with soap and water followed by denatured alcohol. I take a small brush (plumbers used these for flux) and apply the black flocking glue that is supplied with the kit. REALLY apply a lot of this colored glue, do not skimp on it or apply it thin of coat... trust me it is worth it!!! I take my Flocking applicator and start pumping the nylon flocking material on the surfaces evenly. when you think you have enough flocking material on the surface, add more. Do Not touch the flocking this will mat down the fibers and reduce the velvet feel. When you have an excessive amount of fiber on the surface set to the side for 10 hours to dry.

ashtray get this ashtray light w/wire if purchased

AH ashtray light BINGO!

sixth set

fifth set of photos

fourth set of photos

third set of photos

second set of photos

first set of photos

New side marker light sockets 4total $20 New headlight switch dimmer $5 Door light pins 2total $10 Strut rod bushing kit new $20 door hinges 3 w/new pins 1 repop $60.00 Engine mount red primer $40 Engine mount non primer $30 Cross member w/bolts $50 shock tower braces pair $15 Export brace new $30 2 barrel carb $60 1969 C911 & C911 casting 351W heads w/lifters $200 Automatic Pedal assembly w/manual brakes $40 1971 high back seat pair $75 1969 high back seat 1ea $50 Misc seat parts $30 1969 mustang glue in glass brackets (make offer)

so this is pigtailed with, what looks like, the climate control light. It is a small bullet shaped item, with a clip on it and a small hole. Do not know what it was used for. Any suggestions? ryan