newstang

:-) I meant I only have a wholesale account with Dynacorn. Do the NPD bumpers hold up or do they begin to pit after a while? the ones i have from Dynacorn are beginning to show little dots in the chrome after only 2 years

they are expensive and hard to find, but a tilt away column sounds like what you want: https://www.ebay.com/itm/1969-Mustang-Cougar-Tilt-Tilt-Away-Steering-Column/133011065530?hash=item1ef813caba:g:LhUAAOSwB6ZcfDJ3

Oh, it slowed down alright :-) they turned it into a Pinto

Ok guys, need to get bumpers. I hear ACP makes one of the nicest. I only have access to Dynacorn. Rechroming isn't the way I want to spend and not sure the ones I have are original/ What say you?

Thanks for checking, I now have the bottoms from a very generous brother poster. (latoracing)

2015 . with puddle, signal, and heated

these late model mirrors are going on my other 69 project. these require a ton of finesse.

hi thanks, yes i need the bottom and tops thx

Couldn't live with knowing the right side was lower so instead of cutting the aprons off and the radiator, we just cut the top of the apron and rad. support and added to it. Now it is perfectly level.

add a ny and youll have FDNY

i guess this is what i need for the upper ones:

looks like ill have to fab-em

I have the trim for the top and the two fiberglass ends. Do you have any of the brackets?

i found this, it gives a pretty decent layout http://www.relicrecyclery.com/groovygreen/page15/LE600_15.htm

now the question is, where can i get these brackets?

this was very helpful, thanks!

can't really tell but it looks like it has brackets up top on the sides too. There is one person here who will know all this for sure,,,,, RIDGERUNNER !

I'm starting to see how it goes in, the problem is I'm missing brackets. what is needed here? and are there other brackets I need?

So then I assume those standoff brackets need to be removed? what supports the pan forward of where it mounts to the rear?

ha, of course its upside down :-) i didnt even think it would go in the other way :-)

by the way, is that a blower defroster that goes in the center there?

Im not going to do a fold down rear seat because I cant find one for a reasonable price. I got this tray but have no idea what i need to mount it. can anyone shed some light on this?

that would be a waste, I ordered these from summit: VTA-551170 VTA-011069 and the hoses and fittings from vintage air themselves.

I used the vintage air gen IV, don't use the supplied tubes that are pre-bent to go through the firewall, instead use some short straight tubes for the heater core. for the A?C lines, I used the EZ clip hoses and fittings, they are thin and very easy to work with. Be warned these are scary expensive. at least $20 per fitting and the clips and retainer gates are all sold separately as well as the green o-rings. if you are using the 4.6 a/c compressor you will need the adapter for the compressor lines. I forget which compressor I have but look at the label and order an adapter from here: https://coldhose.com/specialty-fittings/compressor-adapters.html On my other build, you can see how I routed it a bit better.

if its a 4.6 you will need to run hydroboost, a power boost wont fit. I'm running stock pedals, again with hydro it works fine. yes on the stock exhaust manifolds, not so much because of the shaft but headers would need to be made custom to clear the frame rails