Leaderboard

@Rcodenewf, it has been a long time since I installed a reproduction w/s (which I assume is what you are using). I looked at a few original doors I have with original w/s on them and on some one end of the w/s is little lifted, some are laying good; lifted ones did not have glue under lifted areas. If your w/s is a good quality (ie soft) then when you glue them, they should confirm. Follow the directions on the glue (ie put it on both sides, wait X minutes for it to get non-tacky etc). Last time I installed door w/s a couple years ago, I re-used the original w/s I removed without damaging it. I used the black 3M which I think holds a little better than the yellow one; do the aft side of the door first, then half of bottom, then other half, then front and glue it in sections. Before gluing, I install it with masking tape and mark the w/s and door in a few places so the ends of w/s matches to the screw holes at both ends of the w/s. Then glue section at a time, and attach per the marks I made on door and w/s. Attach one flat side of the 90 first while butting the 90 degree to the door 90 degree then press the other flat side. If you follow the directions on the glue and if your w/s is soft, glue will confirm the w/s to door. Good luck.

DP90 followed up with Monstaliner rolled on Dark Gray