A few shots of the installed suspension. There were a few steps in between, like welding the brackets to the housing. I've since attached the sway bar and added brake lines.
Instead of changing gears and adding a True Trac, it was pretty much a wash to get a new nodular housing from Quick Performance, with a lower ratio and the True Trac. Then went with 31 spline and new axles. Scope creep. I didn't put the snubber on, not knowing if I'd need it with this suspension. I think I'd have a lot of other problems if it bottomed out. If I need to add it back, please share.
I can't set it up until all the weight is on the car, but it rolls again.